Problems And Solutions - Imetec F4101 Instrucciones De Uso

Switch the appliance off by pressing the ON/OFF (13) button.
Disconnect the plug (14) from the socket.
Wait for the appliance to cool down completely before putting it away. The reservoir
does not have to be emptied.
NOTES:
If the appliance is not to be used for several weeks, empty the water reservoir
(2) completely: wait for the appliance to cool down completely and turn it over
to allow all the water to flow out of the reservoir (2).

PROBLEMS AND SOLUTIONS

This chapter describes the most common problems related to appliance use. If the problems
cannot be resolved with the information below, please contact the Authorised Assistance
Centre.
Problem
The appliance does not go on.
The plate temperature LED (18)
½Å»É ÅÄ ·Äº Å
Smoke comes out of the
appliance when it is switched on
¼ÅÈ Ê¾» ÈÉÊ Ê¿Ã»
Impurities come out of the plate
(15) of the new iron.
Drops of water come out of the
plate (15).
The appliance does not produce
steam.
The plate (15) is dirty: there are
impurities or lime scale residue.
END OF USE
Possible cause
The household appliance is not on.
Normal procedure.
This is absolutely normal and is
due to the expansion of the plastic
material.
This is perfectly normal in a new
iron.
The iron temperature adjustment
knob (12) is set to a low temperature
for steam ironing.
The appliance is not on.
The steam button (16) is not being
pressed.
The water in the reservoir (2) has
Ŀɾ»º ·Äº ʾ» ÄÅ Í·Ê»È 
is on.
The impurities or chemical
substances found in the water
have deposited on the plate.
You are ironing with a temperature
that is too high.
An excessive amount of lime scale
and minerals has accumulated in
the boiler.
Solution
Ensure that the appliance is properly
connected to the socket, that the ON/OFF
button (13) is pressed and the light is on.
¾»  ÉͿʹ¾ ÅÄ Å ¿Äº¿¹·Ê»É ʾ»
¾»·Ê¿Ä½ ƾ·É» ż ʾ» ¿ÈÅÄ ¾» 
once the set temperature is reached.
This no longer occurs after a while.
These particles are completely harmless
and will disappear after the iron is used a
few times.
Adjust the temperature for steam ironing
(see the "IRONING" chapter).
Press the ON/OFF button (13).
Keep the steam button (16) pressed as
you iron.
Fill the water reservoir (2) (see chapter:
Filling the reservoir while ironing).
Wait for the plate to cool down and clean
it with a damp cloth.
Wait for the plate to cool down and clean
it with a damp cloth.
Clean the boiler (see the CLEANING
THE BOILER chapter).
GB
½Å»É Å
15