Connection Examples; Connecting Directly To The Projector - Sony VPH-G90E Manual De Instrucciones

Connection Examples

When making connections:
• Before connecting any cables, make sure that each
piece of equipment to be connected is turned off.
• Use cables appropriate for the equipment to be
connected.
• A loose connection may cause hum or noise.
• When disconnecting a cable, pull it out from the plug;
not the cable itself.
• Also refer to the instruction manual of the equipment
to be connected.

Connecting Directly to the Projector

to video input
Color
monitor
*
IN OUT
TRIGGER LINK
VIDEO IN
to video output
Video equipment
to S video output
* For the VPH-G90E model :
IFB-G90E Video Interface Board (optional)
Use the IFU-1271/1271M Signal Interface Unit.
Rear
VIDEO
OUT
IN OUT
IN OUT Y IN
C IN
VIDEO S VIDEO
VIDEO
IN OUT
RS-232C/422A
RS-232C RS-422A
PLUG IN POWER
CONTROL S DEVICE INDEX
S VIDEO
IN
Setting up
• Set INPUT A in the SET SETTING 1 menu
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote commander.
Connecting a BNC connector:
AC IN
AC power cord (supplied)
to a wall outlet
R G B SYNC/HD VD
R-Y/P Y B-Y/P
R B
INPUT A
IN PJ COM OUT
REMOTE
INPUT A
IFU-1271/1271M
Signal Interface Unit
IFB-12/12A
signal interface
to RGB input
board, etc.
to RGB output
Computer
Installation/connection examples
2 Twist to the right.
1 Align the pins with the pin holes and
push the plug into the socket.
to RGB output
to RGB input
Color
monitor
Signal flow
to RGB.
(page 35 )
(GB)
43
(GB)