Blanking Adjustment - Sony VPH-G90E Manual De Instrucciones

Blanking adjustment

2
Adjust the shift with the arrow keys.
V : The picture is shifted
upward.
v : The picture is shifted
downward.
b : The picture is shifted
rightward.
B : The picture is shifted
leftward.
To adjust precisely, press the RGB SHIFT key again. The projector
enters the FINE adjustment mode, and you can fine adjust the
horizontal shift only. By pressing the RGB SHIFT key again, the
COARSE adjustment mode is resumed.
Note
When the RGB or HDTV signal is input, the adjustable range of the
vertical shift (V SHIFT) can be set to WIDE or NARROW by pressing the
POSITION +/– keys. When the video, S video, component or SDI 4 : 2 : 2
signal is input, V SHIFT is automatically fixed to NARROW and the
adjustable range of the vertical shift will become narrower than that of the
RGB or HDTV signal.
3
Press the MEMORY key to save the adjustment data.
Resetting to the initial preset position
The position of the picture of the video signal can be reset to the initial
preset position by pressing the RESET key in RGB SHIFT adjustment
mode. (The position of the picture of signals other than the video signal
cannot be reset.)
If the displayed picture is larger than the screen, cut off the excess parts.
1
Press the BLKG key.
2
Press the POSITION +/– keys or the BLKG key to select the part to be
adjusted.
• When you press the + key or the
BLKG key, the position cycles
through the following order:
TOP n BOTTOM n LEFT n
RIGHT n TOP ...
• When you press the – key, the
position cycles in reverse order.
3
Adjust with the arrow keys.
• Press the v and V keys to adjust the TOP and BOTTOM positions.
• Press the B and b keys to adjust the LEFT and RIGHT positions.
4
Press the MEMORY key to save the adjustment data.
R G B S H I F T A D J
C O A R S E V S H I F T :
N A R R O W
H c : [ 5 0 ]
ADJ:
H f : 5 0
V : M I N
B L K G A D J
T O P
T : [ 5 0 ]
B : 5 0
L : M A X
R : 5 0
Projecting
Screen
Picture
ADJ:
NEXT: + –
25
(GB)