Switching The Tool On - Hilti PR 3-HVSG A12 Manual De Instrucciones Original

5.2 Inserting the battery
CAUTION
Risk of injury Inadvertent starting of the product.
▶ Check that the product is switched off before fitting the battery.
CAUTION
Electrical hazard. Dirty contacts may cause a short circuit.
▶ Check that the contacts on the battery and on the tool are free from foreign objects before inserting the
battery.
CAUTION
Risk of injury. If the battery is not fitted correctly it may drop out and fall.
▶ Check that the battery is securely seated in the tool so that it cannot drop out and fall, thereby presenting
a hazard to other persons.
▶ Fit the battery and check that the battery is securely seated in the tool.
5.3 Removing the battery
▶ Remove the battery.
6 Operation
6.1

Switching the tool on

▶ Press the ON / OFF button.
After switching on, the tool begins to level itself automatically.
Check the accuracy of the tool before using it for important tasks, especially if it has been dropped
or subjected to unusual influences or impacts etc.
6.2 Working in the horizontal plane
1. Mount the tool on a suitable mounting device.
A wall bracket or tripod may be used as mounting devices. The angle of inclination of the surface
on which it stands should not exceed ± 5°.
2. Press the ON / OFF button. The auto-leveling LED blinks green.
The laser switches on, the beam begins to rotate and the "auto leveling" LED lights as soon as the
tool has leveled itself.
6.3 Working in the vertical plane
1. Place or mount the tool so that the control panel faces upwards.
In order to ensure that the tool's specified accuracy can be maintained, make sure that it is set up
on a level surface or mounted sufficiently level on the tripod or other accessory.
2. Use the visual sighting aids to adjust the tool so that its vertical axis is aligned in the required direction.
The laser switches on, the beam begins to rotate and the "auto leveling" LED lights as soon as the
tool has leveled itself.
3. Press the on/off button. After the tool has leveled itself automatically, it projects a stationary laser beam
vertically downwards. This projected point is the reference point and is used to position the tool.
4. Press the rotation speed button in order to see the laser beam in the entire plane of rotation.
5. The vertically rotating beam can be moved to the left or right by up to 5° by pressing the + and − buttons
on the remote control unit.
18 English
5
6
7
8
2154000
*2154000*