Labels On The Pos; Product Information; Declaration Of Conformity - Hilti POS 150 Manual De Instrucciones Original

1.3

Labels on the POS 150/180

The following labels are applied to the POS 150/180:
1.4

Product information

products are designed for professional users and only trained, authorized personnel are permitted
to operate, service and maintain the products. This personnel must be specifically informed about the
possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Type:
Generation:
Serial no.:
1.5

Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistraße 6 | 86916 Kaufering, DE
2 Safety
2.1 General safety instructions, scanning tools
WARNING! Read all safety precautions and other instructions.
instructions and other instructions can result in electric shock, fire and/or serious injury.
Keep all safety precautions and instructions for future reference.
Work area safety
▶ Keep your workplace clean and well lit. Cluttered or poorly lit workplaces invite accidents.
▶ Do not operate the product in explosive atmospheres, such as in the presence of flammable liquids,
gases or dust. Scanning tools create sparks which can ignite dust, fumes or vapors.
▶ Keep children and other persons clear when the product is in use. Distractions can cause you to
lose control of the product.
Electrical safety
▶ Do not expose the product to rain or moisture. Water entering the product will increase the risk of electric
shock.
Personal safety
▶ Stay alert, watch what you are doing and use common sense when operating a scanning tool. Do
not use a scanning tool while you are tired or under the influence of drugs, alcohol or medication. A
moment of inattention while operating the scanning tool can result in serious personal injury.
16 English
Printed: 08.05.2018 | Doc-Nr: PUB / 5153826 / 000 / 04
Laser radiation. Do not look straight into the laser beam. Laser class
3R.
POS 150/180
01
Failure to observe the safety
2035736
*2035736*