Description - Hilti PT 10 Manual De Instrucciones

Symbols
Read the Disposal of
operating power tools or
instructions appliances and
en
before use. batteries
together with
municipal
waste is not
permissible.
1 These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out

2. Description

2.1 Use of the product as directed
The PT 10 is a quick check device that allows a single person to quickly and accurately check whether the
accuracy of a Hilti rotating laser, point laser or line laser is within the specified tolerance. The accuracy of the
horizontal laser beam is checked in each case.
NOTE
Important! Only Hilti laser tools featuring a visible laser beam can be tested.
2.2 Features
This device allows the user to test the laser tool quickly and easily (takes approx. 50 seconds). Operation of the
device is self-explanatory and the result obtained is clear and unequivocal. The PT 10 is compact and robustly
built.
The accuracy of the following Hilti laser tools can be checked:
PM 10 / PM 24 multidirectional lasers
PML 32 line laser
PMP 34 point laser
PR 10 / PR 15 / PR 16 / PR 20 / PR 25 rotating lasers
PP 10 / PP 11 pipe lasers
Plus new Hilti leveling and alignment lasers (visible-beam type) from future product generations.
2.3 Settings in accordance with the table of Hilti tools
Hilti laser tool
PM 10 / PM 24
PML 32
PMP 34
PP 10 / PP 11
PR 10 / PR 15
PR 16
12
Printed: 07.07.2013 | Doc-Nr: PUB / 5070500 / 000 / 00
cover pages. Keep these pages open while studying
the operating instructions.
In these operating instructions, the designation "the
tool" always refers to the PT 10 quick check device.
Location of identification data on the tool
The type designation and serial number can be found
on the type plate on the tool. Make a note of this data
in your operating instructions and always refer to it
when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
Accuracy class
9
5
9
1
5
3
Filter setting
II
I
II
II
I
I