BH FITNESS G6495FB Instrucciones De Montaje página 16

SAFETY INSTRUCTIONS.-
This product must have an earth
connection. In the event that the
appliance malfunctions then the earth
connection will redirect the electrical
current away from the machine and
reduce the risk of an electrical shock.
This product is supplied with a mains
cable that has an earth wire and a
plug with an earth pin. The plug must
only be used with an appropriate wall
socket, installed
connected to earth, in accordance with
local regulations.
DANGER! If the equipment is not
earthed correctly then there is a risk of
electrical shock. If in doubt, get an
electrician or technical specialist to
check that the earth connection is
correct. Do not modify the plug
supplied with the equipment, if it does
not fit the wall socket then get an
electrician to install
socket that does.
This product must only be used on a
220-240 volt circuit, with an earthed
socket similar to that shown in Fig. A.
Make sure that the appliance is only
connected to a wall socket with the
same pin layout as the plug. Do not
use an adaptor with this appliance.
Always observe
recommendations
electrical appliances:
1 Make sure that the mains supply
voltage matches that of the machine
before plugging it in. The supply
voltage must be the same as that
stated on the characteristics plate and
the holes in wall socket must match
the pins for plug on the machine.
2
shock, first put the switch to the "0"
position and then unplug it from the
wall socket. Always unplug the unit
immediately after use and before
proceeding to clean it.
3
correctly and
switched off and unplugged before
beginning any type of maintenance or
assembly work on it.
4
tugging on the mains cable.
5
cable becomes damaged or worn.
6
surfaces.
SAFETY BREAKER.-
an electrical This model is equipped with an
electronic circuit breaker to protect
both the electronic and electrical
circuits.
This
automatically triggered if the unit is
subjected to abnormal force or heat.
Should this occur:
1.- Set switch (L), located on the
casing, to the "0" (OFF) position Fig.B.
2.- Press the circuit button (C) to reset
the unit.
3.- Next, set switch (L) to the "I" (ON)
position and the unit will be ready for
use again.
Should
repeatedly then the most probable
the following
causes are:
when using
-Abnormal working conditions,
-Treadmill belt in need of lubricant,
-Solvent based lubricants used,
- Belt is too tight.
16
To reduce the risk of electrical
Make sure that the treadmill is
Do not unplug the treadmill by
Do not use the machine if the mains
Keep the mains cable away from hot
safety device
the circuit
will be
breaker trip