Publicidad
Idiomas disponibles
Idiomas disponibles
The display will show the level of
inclination that you finished off on
during your last session.
To lower the inclination to zero with
the unit stopped, press and hold the
STOP key for 5 seconds.
If inclination is not at zero when the
START
key
is
used
exercising, the machine will zero itself
while it is starting.
You can adjust the elevation level by
pressing the INCLINE
specify a value of 0 up to 15,
depending on how you would like to
do the exercise.
Important.
Do
not
inclination level of your treadmill by
propping it up on objects.
IMPORTANT: The inclination level
must be at its lowest setting before
attempting to put the treadmill into
the folded position.
PULSE MEASUREMENT.-
Your pulse rate is measured by
placing both hands on pulse sensors
(R) with which the electronic unit is
equipped.
Fig.3.
The
readout will appear after a few
seconds. The LED beside the pulse
rate value will flash in time with your
heart rate.
IMPORTANT. This is not a medical
appliance and therefore the heart rate
shown
purposes.
to
begin
FITTING THE MONITOR:
First of all, connect terminals (T)
sticking out of the central hole on the
handlebar (1-1) to the rear of the
keys to
monitor (1) Fig.4.
Plug terminals (F, G), sticking out of
the handlebar, Fig.4, into the bottom
of the monitor (1).
change
the
Place the monitor onto the support
plate on the handlebar (1-1), making
sure not to catch any of the cables,
and secure it using washers (134) and
nuts (135).
Next, fit the back cover (6) and tighten
using screws (17), Fig.5.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
pulse
rate
14
is
merely
for
guideline
Publicidad
