Error Codes - BH FITNESS G6495FB Instrucciones De Montaje

FAULT FINDING CHART
PROBLEM
1. The monitor does
not switch on.
2. The monitor
switches on but the
motor fails to start.
3. Walking motion is
jerky on the treadmill
4. The machine
stops (the breaker
trips)
5. Electrical shocks
through the handrail.
6. The treadmill belt
skews off centre

ERROR CODES

Monitor screen displays E1
Monitor screen displays E2
Monitor screen displays E6-E7
Do not hesitate to get in touch with us if you have any queries, by calling:
+44 0844 335 3988
CHECKS
1) Make sure that the
machine is plugged in,
the ON/OFF switch in
position I and that the
safety key is inserted.
2) Check that the
current limiter
pressed in.
3.a) Check that the belt
is lubricated.
3.b) Check the tension
on the sliding belt.
3.c) Check the tension
on the drive belt.
4) Check that the band
is lubricated
5) Check that the
machine is plugged
into an earthed mains
socket.
6.a) Check that the
machine is level on the
floor
6.b) Check that the
machine does not
wobble.
- Speed sensor fault.
- Switch the machine off and on again.
- Elevation fault
service@bh-uk.co.uk
15
SOLUTIONS
1) Plug the machine into
the mains supply.
Set the switch to position I
and insert the safety key.
2) Switch the machine off
and press the
is
breaker in. Lubricate the
treadmill band.
3.a) Lubricate the sliding
belt.
3.b) Adjust the
tension.
3.c) Adjust the drive belt
tension.
4) Reset the overload bu-
tton with the On/Off switch
at "0" and lubricate the
treadmill band.
5) Plug the machine into
an earthed mains socket.
circuit
belt