System Messages - Hofmann geodyna 8250 Manual De Operador

144
7-1
7-2
Trouble shooting
7.1

System messages

The wheel balancer can send messages to the
operator relevant to errors (E codes) (e.g.E2 - Fig. 7-1),
warnings (H-codes) (e.g.H 33 - Fig. 7-2) or Hardware
problems (X-codes). The codes will be described in
the following chapters.
Whenever a code appears:
• Make a note of it.
• Look up the code in the list below.
• Perform the steps described.
Important:
If the code is not listed here, call service team.
Command Error -
Warning -
Fatal error -
7.1.1 E codes
E1
Rim dimensions were entered incorrectly, or
incompletely.
— When the message is displayed, enter data once
again.
E2
Wheel guard is not closed.
E3
Geodata gauge for distance and rim diameter is not
in home position.
E4
The Geodata width gauge arm is not in home position.
E5
Range of compensation exceeded (wheel adaptor has
unacceptable unbalance).
— Press the STOP key or ESC key.
— Check wheel adaptor, repeat compensation run.
E6
During the recalibration the calibration weight was
not fi tted.
— Press the STOP key or ESC key.
— Repeat readjustment.
E7
With this wheel type it is not possible to choose a
weight positioning type.
— If necessary, choose another wheel type.
Message E
Message H
Message 300 or C10