Working With The Machine; Service And Maintenance; Sanding Pad Brake; Eu Declaration Of Conformity - Festool ROTEX RO 90 DX FEQ Manual De Instrucciones

RO 90 DX FEQ
GB
8

Working with the machine

WARNING
Risk of injury

Always secure the workpiece in such a manner
that it cannot move while being machined.
Observe the following instructions:
– Do not overload the machine by pressing with ex-
cessive force! The best sanding results are
achieved with moderate application pressure.
The sanding capacity and quality are mainly de-
pendent on the selection of the correct abrasive.
– Hold the machine with two hands, one on the mo-
tor housing and one on the gear head.
 Tables A and B show the settings we recom-
mend for different sanding and polishing work.
9

Service and maintenance

WARNING
Risk of injury, electric shock

Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!

All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
www.festool.com/Service
EKAT
Use only original Festool spare parts!
4
Order No. at:
www.festool.com/Service
5
3
2
1
To ensure constant air circulation, always keep the
cooling air openings in the motor housing clean and
free of blockages.
The machine is equipped with special carbon
brushes. If they are worn, the power is interrupted
automatically and the machine comes to a stand-
still.
14
9.1

Sanding pad brake

The rubber collar [10-1] on the sanding pad and the
stop ring [10-2] on the machine prevent uncon-
trolled excessive turning of the sanding pad during
eccentric motion (fine sanding). As these parts are
subject to wear in the course of time, they must be
replaced when reduced braking force is observed
(for order no., see spare parts list).
10 Accessories
Only use original sanding and polishing pads from
Festool. Low-quality sanding and polishing pads
may cause serious machine imbalance that de-
creases the quality of the working results and in-
creases machine wear.
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
11 Environment
Do not throw the power tool in your household
waste! Dispose of machines, accessories and pack-
aging at an environmentally responsible recycling
centre. Observe the valid national regulations.
EU only: European Directive 2002/96/EC stipulates
that used electric power tools must be collected
separately and disposed of at an environmentally
responsible recycling centre.
Information on REACh:www.festool.com/reach
12

EU Declaration of Conformity

Gear-driven eccentric sander
RO 90 DX FEQ
Year of CE mark: 2010
We declare under sole responsibility that this prod-
uct complies with all the relevant requirements in
the following Directives, standards and normative
documents:
2006/42/EG, 2004/108/EG, 2011/65/EU, EN 60745-
1, EN 60745-2-4, EN 55014-1, EN 55014-2, EN
61000-3-2, EN 61000-3-3.
Festool Group GmbH & Co. KG
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Martin Zimmer
Head of Research, Development and Technical
Documentation
2013-01-07
Serial no.
495618, 496428