1. Automatic storage
Stores every endpointed reading to the memory automatically.
2. Manual storage
If "Manual Storage" is set, Store appears on the display. Press Store to save endpointed read-
ings.
The endpointed reading can only be stored once. When the data is stored, Store disappears
from the measurement screen.
3. Timed interval readings
A reading is stored to memory every time after a certain interval (3 – 9999 s) defined in the
menu has elapsed. When working in the timed-interval reading mode, the interval by can be
defined by entering the seconds. The measurement series stops according to the selected end-
point format or manually by pressing READ. When timed-interval reading is "on", the DL icon
appears.
For readings lasting longer than 15 minutes, switch off the auto-shutoff function. The Auto-off
over r ide icon appears on the display.
5.5 D ata transfer settings
Interface
Select to transfer the data in the memory to a PC or to a printer. The meter adjusts the baud rate:
Baud rate
Data bits
Parity
Stop bits
Handshake
* If LabX direct is selected, the printout format is always GLP and English. LabX PC direct software
trans l ates the received data into the selected PC language as defined in the regional and language
options.
Printout format
Two different printout formats are available: GLP and Short.
Examples: pH (only SG98)
pH printout GLP
51710917_V02.2011_BA_SG9_98_EnFrEs.indb 23
Printer
PC
1200
9600
8
8
none
none
1
1
none
none
LabX direct*
9600
8
none
1
none
Setup
25
21.04.2011 11:46:03