Transport, Storage And Disposal - melitta Caffeo Solo Manual De Instrucciones

Ocultar thumbs Ver también para Caffeo Solo:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 48
Brewing temperature
From the factory, the brewing temperature
is set to Level 2 (medium
• Switch on the appliance.
• Press the
and
simultaneously until
• Press the
button four times.
illuminates.
• Press the
button, until one of the
three brewing temperatures is set. The
temperature is shown by the beans on
display 9 (from
high).
• Press the
button to confirm the
setting.
Adjusting the grinding fineness
The grinding fineness was set before the
appliance was delivered. We therefore
recommend to only adjust the grinding
fineness after about 1  0 00 coffee
preparations (about 1 year).
The grinding fineness should only be
adjusted immediately after starting coffee
dispensing and only while the mill is
running.
• Pull off the cover 11 to the right.
• Start dispensing coffee
• Put the lever (Image E) in a desired
position (left = fine to right = coarse).
• Insert the cover and swivel to the left
until it clicks in.
Transport, Storage and
Disposal
Venting
The appliance should be vented when
it has not been used for a while or has
been transported. The appliance is then
protected from frost damage.
BA_Solo_082016.indd 23
).
buttons
flashes.
= low to
=
• Remove the water filter if necessary
("Water hardness and filter" page 18)
and keep it cool in a glass filled with tap
water.
• Switch on the appliance.
• Press the
and
simultaneously for ca. 2 seconds.
flashes, and then
• Pull the water reservoir 6 up and out of
the appliance.
• Empty the water reservoir.
• Press the
button. The appliance is
automatically vented and then switched
off.
• Insert the water reservoir into the
appliance.
Transport
• Vent the appliance.
• Empty and clean the drip tray and coffee
grounds container.
• Empty the water reservoir and th bean
container. If necessary, vacuum out
beans that are stuck at the bottom.
• "Cleaning the brewing unit", page 20.
• If possible, transport the appliance in
the original packaging including the hard
foam elements.
Disposal
This appliance is labelled according to
the European Directive 2002/96/EC on
waste electrical and electronic equipment
(WEEE). The Directive prescribes the
framework for a EU-wide applicable return
and recycling of waste appliances. Please
contact a specialised dealer for current
disposal procedures.
buttons
illuminates.
23
21.09.2016 07:23:53

Publicidad

Tabla de contenido
loading

Tabla de contenido