Transport, Storage And Disposal - melitta CAFFEO SOLO Manual De Instrucciones

Adjusting the grinding fineness
The grinding fineness was set before the
appliance was delivered. We therefore
recommend to only adjust the grinding
fineness after about 1 0 00 coffee
preparations (about 1 year).
The grinding fineness should only be
adjusted immediately after starting coffee
dispensing and only while the mill is
running.
• Pull off the cover 11 to the right.
• Start dispensing coffee
• Put the lever (Image E) in a desired
position (left = fine to right = coarse).
• Insert the cover and swivel to the left
until it clicks in.
Transport, Storage and
Disposal
Venting
The appliance should be vented when
it has not been used for a while or has
been transported. The appliance is then
protected from frost damage.
• Remove the water filter if necessary
(„Water hardness and filter", Seite 18)
and keep it cool in a glass filled with tap
water.
• Switch on the appliance.
• Press the and
simultaneously for ca. 2 seconds.
flashes, and then
• Pull the water reservoir 6 up and out of
the appliance.
• Empty the water reservoir.
• Press the button. The appliance is
automatically vented and then switched
off.
• Insert the water reservoir into the
appliance.
buttons
illuminates.
Transport
• Vent the appliance.
• Empty and clean the drip tray and coffee
grounds container.
• Empty the water reservoir and th bean
container. If necessary, vacuum out
beans that are stuck at the bottom.
• „Cleaning the brewing unit", Seite 20.
• If possible, transport the appliance in
the original packaging including the hard
foam elements.
Disposal
This appliance is labelled according to
the European Directive 2002/96/EC on
waste electrical and electronic equipment
(WEEE). The Directive prescribes the
framework for a EU-wide applicable return
and recycling of waste appliances. Please
contact a specialised dealer for current
disposal procedures.
23