Care And Maintenance - Hilti PMD 200 Manual De Instrucciones Original

4. In the top input box, enter either the radius of the arc or the height of the arc above an imaginary axis
joining starting point and end point.
5. In the bottom input box, enter the length of the segments on the arc.
6. Select the layout point that defines the end point of the arc.
7. Select the arc of your choice from the options.
8. To create the points, select Confirm.
▶ The layout tool directly shows you the direction of the first layout point on the arc.
6.9 Settings
Units
▶ You can choose between metric and imperial units of measure.
Pairing with the layout tool
▶ Shows which layout tool the tablet is paired with. Other layout tools within range are listed here.
As soon as it is paired to a tablet, the layout tool no longer appears in the list. You have to unpair
the layout tool before you can pair it with another tablet.
Acoustic signal
▶ You can switch the acoustic signal on or off. In the as-delivered condition, the signal is switched on by
default.
Show intro
▶ You can switch this function on or off. When this function is switched on, the introduction is displayed
when you start the app. In the as-delivered condition, this function is switched on by default.
Show point names
▶ You can switch this function on or off. When this function is switched off, the point names are hidden. In
the as-delivered condition, this function is switched on by default.
About us
▶ Use this function to view information about the software version, the tool's firmware version, licenses
and legal matters.
7

Care and maintenance

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt from the tool.
• Carefully remove dust with a dry brush or cloth.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the cordless tool if signs of damage are found or if parts malfunction. Have the tool
repaired by Hilti Service immediately.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
Cleaning the laser exit window
▶ Blow dust off the laser exit window.
26 English 2275630
*2275630*