Hilti PMD 200 Manual De Instrucciones Original página 32

Trouble or fault
Layout tool cannot measure.
Red laser dot or green laser
line not visible.
Green laser line is not per-
fectly vertical.
The green laser line and the
red laser dot are not perfectly
superimposed. (Deviations of
+/- 1-2 mm (0.04-0.08 in) are
normal.)
Layout points are not correct
/ existing layout points are
not correct after a reposition-
ing
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
28 English
Possible cause
Lighting conditions on site are too
bright.
Unsuitable target surface
Lighting conditions on site are too
bright.
Layout tool and tablet are not
paired
Layout tool is experiencing a fault.
Leveling faulty
Layout tool is experiencing a fault.
Layout tool is experiencing a fault.
Target plate not leveled
Target plate is damaged
The control line is too short
The layout tool was moved
Action to be taken
▶ Darken or shade the working
area.
▶ Change the target surface (e.g.
white paper).
▶ Darken or shade the working
area.
▶ Pair layout tool and tablet.
→ page 23
▶ Switch the layout tool off and
then on again. If the problem
persists, consult Hilti Service.
▶ Switch the layout tool off and
then on again. If the problem
persists, consult Hilti Service.
▶ Switch the layout tool off and
then on again. If the problem
persists, consult Hilti Service.
▶ Switch the layout tool off and
then on again. If the problem
persists, consult Hilti Service.
▶ Make sure that the layout tool is
checked at regular intervals.
▶ Before each marking, level the
target plate with the adjusting
screw. → page 25
▶ Check the target plate for
deformation; replace it if
necessary.
▶ Exit the current layout. Repeat
station setting of the layout
tool with a longer control line.
→ page 23
▶ Exit the current layout. Repeat
station setting of the layout tool.
→ page 23
2275630
*2275630*