Establishing Power Supply - Seca 287 Manual Del Usuario

4.4 Establishing power supply

74 •
The device is powered by a power supply unit.
The connection for the power supply unit is located underneath the lower part
of the device. To establish the power supply, proceed as outlined below.
CAUTION!
Risk of injury and damage to device
The device must be tilted. The significant height of the assembled
device can lead to injuries and damage to the device.
►
Ensure that there is no-one else in the immediate vicinity.
►
Ensure that there are no objects in the immediate vicinity.
1. Tilt the device so that the power supply connection socket is accessible.
ATTENTION!
Damage to device as a result of excessive voltage
Commercially-available power supply units may deliver a higher
voltage than they quote. The scale may overheat, catch fire, melt or
short-circuit.
►
Use only original seca plug-in power supply units with controlled
12 V output voltage.
2. Insert the device connector of the power supply unit into the power
supply connecting socket of the scale.
3. Carefully return the device to an upright position.
4. Plug the power supply unit into a power supply socket.