Deleting Values Automatically (Aclr); Deactivating Ultrasound Measurement; Switching Between Bmi And Bfr - Seca 287 Manual Del Usuario

Deleting values automatically
Deactivating ultrasound
measurement

Switching between BMI and BFR

Out-of-date measured results and patient data lead to incorrect calculation of
BMI or BFR. You can set the device so that the measured results and patient
(ACLr)
data below are automatically deleted after 5 minutes:
• gender
• physical activity level (PAL)
• age
• height
• BMI
• BFR
NOTE:
• If you want to enter PAL, age and gender (input function) for the
next measurement, the values of the previous measurement will be
suggested again (see "Entering patient data (input)" on page 78).
• This function is activated at the factory on some models. You can
deactivate the function if desired.
1. Select the item "ACLr" from the menu.
2. Confirm your selection.
The current setting is displayed.
3. Select the desired setting:
– On
– Off
4. Confirm your selection.
You exit the menu automatically.
Patient data, height and BMI/BFR will in each case be deleted 5 minutes
after a measurement. "----" will be displayed instead.
The gender symbol will go out.
You can deactivate height measurement if you just want to use the weighing
function.
NOTE:
If you deactivate ultrasound measurement, this will be reactivated
automatically when you restart the device.
1. Select the item "ULtrA" from the menu.
2. Confirm your selection.
3. Select the desired setting:
– Off
4. Confirm your selection.
You exit the menu automatically.
You can select whether the measuring station calculates body mass index
(BMI) or body fat rate (BFR). The current setting is displayed permanently in
the multifunctional display.
The calculation is performed automatically as soon as the measuring station
has determined the patient's weight and height.
NOTE:
If the BFR function is activated, the measured results are not
announced by voice output.
1. Select the item "bodY" from the menu.
English
Operation • 85