Assembly And Adjustment - WAGNER HT4500 Manual De Instrucciones

EN

7. ASSEMBLY AND ADJUSTMENT

Prior to assembly and adjustment always unplug the tool and allow to cool
fully.
The air temperature can be adjusted to suit a wide range of applications. The table below
suggests settings for different applications.
Setting Applications
1
 Drying paint, varnish colour shade samples, filler, adhesives, construction
0-50ºc
 Drying wet timber prior to filling
 Removing stickers
 Joining adhesives-large-surface gluing with contact adhesives, activation of
 Waxing and de-waxing
 Shrinking PVC wrapping and insulation tubes
 Thawing icy stairs and steps, door locks, car boot lids, car doors or
>>>>water pipes
2
 Welding of thermoplastic polymer, flooring materials of PVC and linoleum,
50-650ºc
 Bending plastic pipes and sheets
 Soldering joints, tin, special silver solder, SMD elements, cable lugs
 Loosening rusted or tightly-fastened nuts and bolts
 Removing old and even thick coatings of oil paint , lacquer, varnish and
If you are not sure about the correct setting, start with a low temperature
setting and gradually increase the temperature until you achieve optimum
results.
ATTENTION: RISK OF FIRE! Do not excessively heat the wood surface.
joints and stucco forms
pressure-sensitive adhesives, acceleration of bonding processes, releasing
of bonding points as well as releasing or bonding of edge band or veneer
PVC-coated fabric, tarpaulins and foils
synthetic plaster
8