Cooling Down; Maintenance And Cleaning; Technical Data - WAGNER HT4500 Manual De Instrucciones

8.4 STATIONARY USE
 This tool can also be used in stationary mode.
 Place the tool onto the workbench with the gun nozzle facing upwards.
 Secure the power cord to prevent pulling the tool off the workbench.
 Carefully switch the tool on.

8.5 COOLING DOWN

The nozzle and accessory become very hot during use. Let these parts cool down for 30
mins before attempting to move or store the tool.
 To reduce cooling time set temperature to lowest setting and airflow to maximum and allow
>>to run for a few minutes.
 Switch the tool off and allow to cool for at least 30 minutes.

9. MAINTENANCE AND CLEANING

ATTENTION! Before performing any work on the equipment, disconnect
from the power supply.
9.1 MAINTENANCE
 Your heat gun has been designed to operate over a long period of time with a minimum
>>of maintenance. Continuous satisfactory operation depends upon proper tool care and
>>regular cleaning.
9.2 LUBRICATION
 Your heat gun requires no additional lubrication.
9.3 CLEANING
 Keep the ventilation slots clean and free from dust and dirt to prevent overheating of the
>>gun.
 Regularly clean the gun housing with a soft cloth, preferably after each use.
>>If the dirt does not come off use a soft cloth moistened with soapy water.
NEVER use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.

10. TECHNICAL DATA

Power Supply
Max Output
Air Temperature / Flow
11. TROUBLESHOOTING
If a problem occurs always switch off and unplug the unit immediately at the mains socket-
outlet.
Heat gun does not turn on
220-240V 50-60Hz
2000W
1) 50°C;
2) 50-650°C；250-500L/min
Check fuse is intact and is rated 13 Amps and BS 1362
.approved.
If necessary, replace with an identical fuse.
11
250-500L/min
EN