Settings - Festool RTSC 400 Li Manual De Instrucciones

sources. The mains adapter enables the mobile
dust extractor's automatic electronic switch-
on/shut-off function.
For older mobile dust extractors, the
automatic electronic switch-on/shut-
off may only be activated under load
and not yet under no-load speed due
to low power consumption.
► Insert the mains adapter [3a]
► Connect the mains adapter and plug-it ca­
ble [3b]
► Remove the mains adapter [3c]
► Detach the mains adapter from the plug-it
cable [3d]
3a
2
1
1
3c
2

8 Settings

WARNING
Risk of injury
► When working on power tools, always re­
move the batteries or disconnect the mains
adapter first.
8.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Temperature cut-out
To avoid the motor overheating, the power con­
sumption is limited at an excessive motor tem­
perature. If the temperature continues to rise,
3b
1
2
3d
2
1
the power tool switches off and can only be
switched on again once the motor has cooled
sufficiently.
Constant speed
The preselected motor speed is kept constant
through electronic control. This means that, if
the machine is used as intended (reasonable
contact pressure), a constant sanding speed is
achieved.
Setting and adjusting the speed
The speed can be set [1-5] between 6000 and
10000 min using the adjusting wheel.
-1
For sanding, we recommend the following set­
tings for the adjusting wheel [1-5]:
Sanding work
– Sanding with max. abrasion
– Sanding off old paint
– Sanding of wood and ven­
eered surface prior to paint­
work
– Intermediate sanding of
paintwork on surfaces
– Sanding thinly applied under­
coat
– Sanding wood with sanding
cloth
– Edge breaking on wooden
parts
– Smoothing primed wooden
surfaces
– Sanding solid wood and ven­
eered edges
– Sanding rebate of windows
and doors
– Intermediate sanding of
paintwork at edges
– Light sanding of natural
wood windows using sanding
cloth
– Smoothing wooden surfaces
using sanding cloth before
staining
– Rubbing or removing excess
limestone residue using
sanding cloth
English
Adjusting wheel setting
5-6
4-5
3-4
11