Makita LS1216 Manual De Instrucciones página 20

1
2
3
009521
2
1
3
009522
Fig. B: At right 45° miter angle
Fig. C: At left 45° miter angle
Position crown molding with its WALL CONTACT
EDGE against the guide fence and its CEILING
CONTACT EDGE against the crown molding
stoppers as shown in the figure. Adjust the crown
molding stoppers according to the size of the
crown molding. Tighten the screws to secure the
crown molding stoppers. Refer to the table (C) for
the miter angle.
1
009520
Position in
Miter angle
Fig. A
(1) Right 45°
For inside
corner
(2)
Left 45°
(3)
For outside
corner
(4) Right 45°
006365
1. Crown molding
stopper L
(Optional
accessory)
2. Crown molding
stopper R
(Optional
accessory)
3. Turn base
1. Crown molding
stopper L
2. Crown molding
stopper R
3. Turn base
1. Guide fence
2. Crown molding
2
Table (C)
Finished piece
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade
7. Cutting aluminum extrusion
009523
When securing aluminum extrusions, use spacer
blocks or pieces of scrap as shown in the figure to
prevent deformation of the aluminum. Use a
cutting lubricant when cutting the aluminum
extrusion to prevent build-up of the aluminum
material on the blade.
CAUTION:
Never attempt to cut thick or round aluminum
•
extrusions. Thick aluminum extrusions may come
loose during operation and round aluminum
extrusions cannot be secured firmly with this tool.
8. Wood facing
Use of wood facing helps to assure splinter-free
cuts in workpieces. Attach a wood facing to the
guide fence using the holes in the guide fence and
6 mm (1/4") screws.
See the figure concerning the dimensions for a
suggested wood facing.
Over
15mm(9/16")
Over 290mm(11-3/8")
1 135mm
(5-5/16")
1. Hole
010047
CAUTION:
Use straight wood of even thickness as the wood
•
facing.
When cutting workpieces from 107 mm (4 -1/4") to
•
120 mm (4 - 3/4") high, use a wood facing to
prevent a portion of the workpiece near the guide
fence from being left uncut.
20
1. Guide fence
1
2. Vise
2
3. Spacer block
4. Aluminum
3
extrusion
4
5 5. Spacer block
Over 340mm(13-3/8")
106mm 116mm 180mm
(4-3/16") (4-9/16") (7-1/8")
1