After Use - Makita LS1216 Manual De Instrucciones

Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
009516
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10
minutes. Then check the tool while running and electric
brake operation when releasing the switch trigger. If
electric brake is not working well, ask your local Makita
service center for repair.

After use

After use, wipe off chips and dust adhering to the
•
tool with a cloth or the like. Keep the blade guard
clean according to the directions in the previously
covered section titled "Blade guard". Lubricate the
sliding portions with machine oil to prevent rust.
When storing the tool, pull the carriage toward you
•
fully so that the slide pole is thoroughly inserted
into the turn base.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Steel & Carbide-tipped saw blades
•
1. Screwdriver
1
2. Brush holder
cap
2
or attachments
Only use accessory or
Miter saw blades
Combination
Crosscutting
Fine cross cuts
Non-ferrous metals
miter saw blades
006526
Vise assembly (Horizontal vise)
•
Vertical vise
•
Socket wrench 13
•
Holder
•
Dust bag
•
Crown molding stopper set
•
Triangular rule
•
Dust box
•
Hex wrench (for LS1216L)
•
are
25
For smooth and precise cutting in various materials.
General purpose blade for fast and smooth rip,
crosscuts and miters.
For smoother cross grain cuts. Slices cleanly
against the grain.
For sand-free cuts cleanly against the grain.
For miters in aluminum, copper, brass, tubing,
and other non-ferrous metals.