Ism Data - Mettler Toledo SevenCompact S210 Instrucciones De Manejo

4 Press Exit to cancel.
After deletion, the sensor ID disappears from the list in the sensor ID menu.
Note
● An active sensor ID cannot be deleted.
●
This menu is protected by a deletion PIN code. Upon delivery, the PIN code is set to 000000.
Change the PIN code to prevent unauthorized access.
Export to USB-stick
Stored calibration data per sensor ID can be transferred to a USB-stick.
1 Press Select.
2 Select a sensor ID from the list.
3 Press Transfer to export the calibration data of the selected sensor ID to the USB-stick.
7.4 ISM data
SevenCompact meter incorporates Intelligent Sensor Management (ISM
functionality provides extra security, safety and eliminates mistakes. The most important features are:
Extra security!
● After connecting the ISM
serial number are transferred from the sensor chip to the meter. The data is also printed on the
GLP printout.
● After calibration of the ISM
the sensor chip. The most recent data is always stored where it should be – on the sensor chip!
Extra safety!
After connecting the ISM
can be reviewed to see the development of the sensor over time. This information provides an indica­
tion if the sensor should be cleaned or renewed.
Eliminate mistakes!
After connecting an ISM
ments.
Additional features are described below.
Initial calibration data
®
When an ISM sensor is connected, the initial calibration data in the sensor can be reviewed or trans­
ferred. The following data is included:
● Response time
● Temperature tolerance
● Membrane resistance
● Slope (at pH 7) and offset
● Type (and name) of electrode (for example, InLab Expert Pro ISM
● Serial number (SN) and ordering (ME) number
● Production date
Calibration history
The last 5 calibrations data stored in ISM
transferred.
Maximum temperature
The maximum temperature that the ISM
tored automatically and can be reviewed for the evaluation of the electrode lifetime.
®
sensor, the sensor is automatically recognized and the sensor ID and
®
sensor, the calibration data is automatically stored from the meter to
®
sensor, the five most recent calibrations are transferred to the meter. These
®
sensor, the last set of calibration data is automatically used for measure­
®
sensor including current calibration can be reviewed or
®
sensor has been exposed to during measurement is moni­
®
) technology. This ingenious
®
)
Data management 33