Installation - Aventics RMC Serie Instrucciones De Servicio

6

Installation

The RMC-Zylinder is configured and dimensioned for a particular application. It must never be
altered or modified from its original configuration.
Check that the maximum values for working pressure, load, torque or speed stated in the
technical specifications are not exceeded.
Risk of injury or damage due to uncontrolled rod movements!
If compressed air is connected while the cylinder is being installed, someone may be injured
or the system may be damaged.
Make sure that the relevant part of the system is depressurised while the cylinder is
being installed.
Make sure that the cylinder is completely installed before connecting compressed air.
If the system has to be left unattended during installation, make sure that the
compressed air supply cannot be reconnected.
Watch out for suspended loads!
Where the unit is installed vertically, a suspended load may drop out of control if the
compressed air is shut off. This may result in injury.
Always secure the area under a suspended load to prevent people entering it.
Risk of heavy objects!
Some configurations of the RMC-Zylinder are very heavy. Lifting them incorrectly may cause
injury.
When lifting the cylinder, take steps to avoid damaging it. Heavy cylinders must be
carried by two people or by one person with lifting aids.
AVENTICS | RCM | R402002349-BDL-001-AC
WARNING
WARNING
CAUTION
49
Installation