Metz MECABLITZ 54 MZ-3 Instrucciones De Manejo página 108

Troubleshooting hints
Cosa fare in caso di anomalie
En caso de problemas
remote address (remote channel) "Ad1" or "Ad2"
instead of the correction value.
(Ni): The Nikon fill-in flash function "Matrix-control-
led fill-in flash" or "3D multi-sensor fill-in flash"
cannot be set on the mecablitz.
• The given fill-in flash mode can only be set on the
mecablitz if the latter has been fitted with an SCA
3402 adapter and mounted on a switched-on camera
that supports the given fill-in flash function. Data
exchange between camera and SCA adapter must
have taken place at least once (simply tap the camera
release lightly without tripping the shutter).
• "3D multisensor fill-in flash" (Nikon) is not supported
in remote mode, when the main reflector is swivelled
out of its basic position or when the secondary reflec-
tor has been switched on. Consequently, this function
cannot be activated under the above conditions.
• The given controlled Nikon fill-in flash mode depends
on the given camera model.
The aperture symbol
LC display of the mecablitz.
• The light-controlling range of the mecablitz in automa-
tic flash mode is being exceeded under the given pic-
ture-shooting conditions or with the given camera set-
tings.
Remedy: Darken the ambient area of the shot; load a
less sensitive film; or set a smaller aperture opening
on the camera or mecablitz.
The AF red-light emitter of the mecablitz is not
activated
Possible causes:
• Ambient light is sufficient for the camera's AF sensor
to enable focusing.
• If necessary the camera will activate its own AF illumi-
nator.
• An AF mode other than Single-AF (S) has been activa-
ted.
• A decentral AF metering area has been activated on
the camera.
Remedy:
• Set the Single-AF or S camera AF operating mode (see
the operating instructions for the given camera).
• Activate the central AF sensor in the camera's viewfin-
der.
108
and stop value flash on the