Assessing The Overall Lighting Conditions In Remote Mode - Metz MECABLITZ 54 MZ-3 Instrucciones De Manejo

Metz A-Remote mode
Metz a distanza senza cavi in Modo Auto
Funcionamiento Remoto A de Metz
• Set a shutter speed of 1/60th sec. or slower.
• Switch on the mecablitz on the camera with the main
switch.
• Depress the MODE button repeatedly until A appears
on the display.
• While the A mode is flashing, turn the setting disk and
select the address Ad1 or Ad2 for the Co controller
mode. Depress the MODE button in the event that A no
longer flashes. To store, briefly press the setting disk in
the direction of the arrow. The selected setting will be
automatically stored after 5 seconds if the setting disk
is not pressed. A will then be continuously displayed
(without flashing), together with Co and the slave
address Ad1 or Ad2.
Setting procedure for Metz auto remote slave mode:
The setting procedure is the same as for Metz TTL remo-
te slave mode.
7.3 Assessing the overall lighting conditions in
remote mode
A modelling light beam of all participating flash units can
be fired to assess the overall lighting conditions in A
(auto) and TTL remote mode.
For this purpose, the
on the camera must be programmed. Press the Select
button repeatedly until the mode display
Turn the setting disk to set the modelling light function
to ON or OFF. The modelling light can then be fired with
the button; see also Chapter 12.
46
button of the 54 MZ-3 mounted
lights up.