Engine Maintenance; Servicing The Air Cleaner - Toro Timecutter Z4200 Manual Del Operador

,
Connect a grease gun to each fitting (Figure 21 and
Figure 22). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5. Wipe up any excess grease.
Engine Maintenance
Servicing the Air Cleaner
Service Interval: Before each use or dail3_Check the
air cleaner for dirb, loose or damaged
parts.
This engine is equipped with a replaceable, high density
paper air cleaner element. Check the air cleaner daily or
before starting the engine. Check for a buildup of dirt
and debris around the air cleaner system. Keep this area
dean. Also check for loose or damaged components.
Replace all bent or damaged air cleaner components.
Note: Operating the engine with loose or damaged air
cleaner components could allow unfiltered air into the
engine causing premature wear and failure.
Note: Service the air cleaner more often under
extremely dusb. dirty conditions.
o
G005300 J
Figure 23
1. Knobs, air cleaner cover 3. Paper element
2. Air cleaner cover 4. Air cleaner base
Servicing Paper Element
Service Interval: Every 25 hours--Service the paper
dement. (more often under extremely
dust B dirty conditions)
Every 100 hours--Replace the paper
dement. (more often under extremely
dust B dirty conditions)
1. Remove the air cleaner cover (Figure 23).
2. Remove the air cleaner element with the integral
rubber seal (Figure 23).
3. Gently tap the pleated side of the paper element to
dislodge dirt. Do not wash the paper dement or
use pressurized air, as this will damage the element.
24