Pp 10 / 25 Pipe Laser - Hilti PP 10 Manual De Instrucciones

ORIGINAL OPERATING INSTRUCTIONS

PP 10 / 25 pipe laser

It is essential that the operating instruc-
tions are read before the tool is operated
for the first time.
Always keep these operating instructions
together with the tool.
Ensure that the operating instructions are
with the tool when it is given to other per-
sons.
Contents
1. General information
2. Description
3. Accessories
4. Technical data
5. Safety instructions
6. Before use
7. Operation
8. Care and maintenance
9. Troubleshooting
10. Disposal
11. Manufacturer's warranty - tools
12. FCC statement (applicable in US) / IC
statement (applicable in Canada)
13. EC declaration of conformity
1 These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out
cover pages. Keep these pages open while studying
the operating instructions.
In these operating instructions, the designation "the
tool" always refers to the PP 10/25 pipe laser.
PP 10 / 25 pipe laser 1
@
Remote control signal receiving window
;
Warning / standby LED
Printed: 07.07.2013 | Doc-Nr: PUB / 5070160 / 000 / 00
=
Control panel
%
Display
&
Grip
(
Grip mount
)
PPA 84 cable connector
+
Battery compartment cover lock
§
PPA 82 battery incl. mains adaptor
/
Plumb spot
PP 10 / 25 pipe laser
:
Laser exit window
·
Remote control signal receiving window
$
Plumb spot
£
Page
Pivot point mark
18
19
Control panel
|
20 Direction control / auto-centering button
¡
20
Plumb spot button
Q
21
Laser beam mode button
W
23
Remote control signal receiving window
E
24
"Lock" button
R
29
Target plate auto-centering button
T
29
Direction control / auto-centering button
Z
30
SET button
U
30
Laser beam up / down, value-entry button
I
Warning / standby LED
O
31
Laser beam up / down, value-entry button
P
31
ON / OFF button
PRA 20 remote control unit 2
@
Signal transmission aperture
;
Signal LED (blinks red when a signal is trans-
mitted)
=
Target plate auto-centering button
%
Self-centering buttons (press both simultan-
eously)
&
Button to move target axis to the left
(
Button to move target axis to the right
)
ON / OFF button
+
Laser beam mode button
en
17