Hilti PP 10 Manual De Instrucciones página 30

7.2 Symbols in the display 5
1 Plumb spot indicator.
2 Alignment indicator
3 Battery status indicator
4 Self-leveling indicator
5 Inclination indicator
6 Percentage
7 Lock symbol
8 Electronic bubble level
9 Laser mode display
7.3 Warnings displayed 6
1 Battery status warning
2 Leveling warning
3 Transverse inclination
warning
7.4 Switching the tool on
Press the ON / OFF button.
NOTE
The PP 10/25 is capable of leveling itself within a
range of +/- 10%. The tool levels itself automatically
when set up within this range. The LED begins to
blink when the inclination of the tool is more than +/-
10% from the set inclination. The tool should then be
rotated in the direction indicated by the arrow.
7.5 Setting the inclination 7
Inclination can be set either manually or automatically.
Inclination can be set within the -15% to +40% range
(for inclinations over 10%, an accessory or other aid
is used to provide initial inclination of the laser tool).
7.5.1 Automatic entry of inclination 7
1. Switch the tool on by pressing the ON / OFF
button.
2. Press the SET button. The set value is displayed
and the ± indicator blinks.
3. Press the laser beam UP or DOWN button to
change the sign.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070160 / 000 / 00
Shows that the plumb spot is active.
Indicates laser beam alignment.
Remaining battery capacity is shown in 3 levels.
Blinks while the laser is leveling itself. The display subsequently
changes to the laser mode set.
Shows the selected inclination.
Shows the unit of measurement selected (percentage or per thou-
sand).
The values entered cannot be changed.
Shows whether the tool is leveled correctly.
The laser modes "blinking", "normal" and "high-power" (PP25) are
shown.
Operation is no longer possible. Replace / recharge the battery or
connect an external power source.
The laser is tilted beyond its self-leveling range. Tilt the laser tool in
the direction of the arrow shown in the display.
The laser tool has been rotated beyond its self-leveling range. Rotate
the laser tool in the direction of the arrow shown in the display.
4. Press the right-hand direction control button
in order to reach the correct position (the left
direction control button can be used to move
back).
5. Press the laser beam UP or DOWN button to
change the value.
6. Press the right-hand direction control button to
move to the next position.
7. Press the laser beam UP or DOWN button to
change the value. Repeat the steps described
above to change other numerical values.
8. Press the SET button when the value entered is
correct.
The laser beam then begins to move to the
specified setting.
7.5.2 Manual entry of inclination
NOTE
Inclination can also be set directly by moving the laser
beam. Check that the locking function has not been
activated.
en
25