Hilti PP 10 Manual De Instrucciones página 32

3 The display indicates that
searching (auto centering)
is in progress.
4 Automatic alignment has
been completed.
5 Error during automatic
alignment.
7.12 Selecting the laser beam mode
Press the laser beam mode button as often as neces-
sary until the desired display mode is shown in the
display.
Constant beam
Blinking beam
High-power mode (only with the PP 25)
7.13 Adjusting the electronic bubble level 10
When the tool is pivoted, the bubble level appears
clearly in the display.
Adjust the tool until the "bubble" is in the center of
the display.
7.16 Target plate, front 12
1 Locking screw
2 Target plate, small
3 Bubble level
4 Target plate holder
7.17 Target plate, rear (2) 12
5 Reflective strip
7.18 Setting parameters
7.18.1 Setting units of measurement to % or ‰
1. Press the ON / OFF button and the LOCK button
at the same time.
The set values are shown in the display.
2. Use the laser beam UP / DOWN button to move
to the "unit" line.
3. Select the value you wish to change by pressing
the direction control button.
4. Press the SET button to confirm the entry.
The tool then returns to the normal operating
mode.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070160 / 000 / 00
Searching (auto centering) then begins.
Check the position of the laser spot on the target plate.
NOTE If necessary, the remote control or the direction control but-
tons on the tool (left / right) can be used to readjust the position of
the beam.
If the beam loses contact with the target plate while searching, the
procedure must be restarted.
The LED begins to blink as soon as the tool's com-
pensation range is exceeded.
7.14 Fitting the screw feet and centering
screw 11
Fit the appropriate feet for the pipe diameter before
setting up the laser in the pipe.
NOTE
Feet are available in the sizes 150 mm, 200 mm,
250 mm and 300 mm (6", 8", 10", 12").
7.15 Setting the target plate size 12
Set the target plate size to a value suitable for the pipe
diameter you are working with.
Secures the target plate at the desired height.
Target plate for 150 mm to 250 mm.
For setting up the target plate horizontally.
For automatic alignment.
7.18.2 Setting and activating the security code
Unauthorized persons can be prevented from using
the laser tool by entering a 4-digit security code.
Please note that once the security code has been
activated, the laser tool can no longer be operated
without entering this code. The code will be requested
automatically after the tool is switched on.
1. Press the ON / OFF button and the LOCK button
at the same time.
The set values are shown in the display.
2. Use the laser beam UP / DOWN button to move
to the "input S code" line.
en
27