Hilti PP 10 Manual De Instrucciones página 31

The value indicated becomes higher or lower as the
laser beam is moved.
1. Press the laser beam UP or DOWN button. The
laser beam then moves up or down.
en
7.7 Beam position indicator 8
1 Beam position indicator
2 End position left
3 End position right
7.8 Adjusting the position of the beam 8
The maximum lateral adjustment range is 9m at a
distance of 30m. The speed of movement can be
varied.
If the button is pressed briefly, the laser beam moves
slowly.
If the button is pressed for longer, the laser beam
moves quickly.
The current position of the beam can be read from
the display at any time.
7.8.1 Adjusting the beam end position left / right
The display informs the operator when the beam has
reached the left or right end position and cannot
be moved further. The display blinks to inform the
operator of this status.
7.11 Display while searching 9
1 The laser tool is not yet
ready for automatic align-
ment.
2 The display indicates sta-
bilization of the laser beam
after self-leveling.
26
Printed: 07.07.2013 | Doc-Nr: PUB / 5070160 / 000 / 00
2. Press the laser beam UP and DOWN buttons at
the same time to move the laser beam to the zero
position.
The laser beam moves immediately to the
0.000% position.
7.6 Aligning the target line 8
Use the direction control buttons on the PP 10/25 or
PPA 20 remote control unit to move the laser beam
horizontally to the right or left.
Shows the direction of the laser beam relative to the tool.
Shows that the laser beam cannot be aimed further to the left.
Shows that the laser beam cannot be aimed further to the right.
If this position is reached frequently it is recommen-
ded that the tool is pivoted slightly to the left or right
and the beam then realigned.
7.9 Automatic centering
Press the two direction control buttons (left and right)
at the same time.
The laser beam returns to the center automatically.
7.10 Automatic alignment with the target
plate 9
1. Set up the target plate with the reflective strips
facing the laser tool.
2. Press the target plate auto-centering button.
NOTE This function may take up to 2 minutes
before starting.
The tool then searches for the target plate within
its alignment range (left/right).
The tool has not yet completed the self-leveling procedure.
NOTE This procedure will first be completed.
Please wait until this operation has been completed.