JVC DT-V21G11 Manual De Instrucciones página 19

SCOPE SETTING*
Configure the settings for the wave form monitor and vector scope.
Item Content
GAIN Adjust the input gain level.
SIZE * Set the window size.
2
POSITION * Select the window position.
2
TRANSPARENT Activates/deactivates the function to make the window translucent.
ON
OFF
AUTO OFF Set the function to turn off the window automatically 15 minutes after displayed.
WAVE DISPLAY Select a wave form to be displayed for the wave form monitor.
WAVE FILTER Turn on/off the lowpass filter to put over the input wave form data.
WAVE OVER LEVEL Set the over levels of the luminance signals (Y) and RGB signals.
Example of the wave form monitor
Ex.: When the luminance signal is Y, "MARKING" is set to "ON" and "LEVEL" is set to
"080"
• The wave form color of signals over the value specified in "LEVEL" turns red.
• The display differs depending on the input signal or the "WAVE DISPLAY" setting.
– MARKING Turn on/off the function to change the wave form color of signals over the value
specified in "LEVEL." (☞ below)
– LEVEL Adjust the lower limit for the over level.
* 1 The wave form monitor is not displayed when the input signals are DVI (input from a computer). The vector scope is not displayed when the input
signals are RGB.
* 2 When "SIZE" is set to "LARGE," the window is displayed in the center of the screen regardless of the "POSITION" setting.
SYNC FUNCTION
Settings for the synchronization with signals.
Item Content
NO SYNC ACTION Select the screen status when no signal is coming in.
P.SAVE
GRAY B.
DELAY TIME Select the period until the screen status changes as selected in "NO SYNC ACTION" after
signals stop coming in.
LOW LATENCY Activates/deactivates the function to shorten the time taken to display the picture.
• If the picture is not displayed steadily while "ON" is selected, select "OFF."
• While "ON" is selected, the displayed picture may become unstable when an operation
using buttons on the front panel or the menu is performed, or when the signal format
changes.
●
When setting "NO SYNC ACTION" to "GRAY B.," the screen color changes to gray and the power consumption of the back light is saved by
half. Selecting "P.SAVE" (power save mode) saves more power consumption by turning off the back light.
1
: Translucent
: Normal
Red
Y
Image signals
Start
: Power save mode
: Gray screen
White
End
Setting value
–10 – +10
NORMAL, LARGE
1 (Lower right), 2 (Lower left),
3 (Upper left), 4 (Upper right)
ON
OFF
ON, OFF
Y, Pb, Pr (HD signal)
Y, Cb, Cr (SD signal)
R, G, B (RGB signal)
FLAT (No filter)
LOWPASS
Example of the vector scope
Ex.: When the color bar is
displayed
OFF, ON
070 – 109
Setting value
OFF
P.SAVE
GRAY B.
30sec., 5min., 15min.
ON
OFF
17
EN EN