Configuration - Interacoustics MT10 Manual De Instrucciones

MT10 Instruction for Use - EN
NOTE:
Please be aware that when connecting the USB IR receiver and the Sanibell II printer at the same
time, the printer may start printing out nonsense data from the PC because the Infrared receivers may
interfere with each other. However, it does not happen often that users will send data to their PC as
well as print out the data on the wireless printer. IF the scenario occurs, please see that the two IR
windows on these devices are not pointed directly at each other.

CONFIGURATION

PRINT RECORDS
SEND RECORDS TO
PC
TODAY'S DATE
REFLEX SELECTION
(if your version has this
feature)
"ALL SENT RECORDS" – Delete all records that
have been sent to a PC.
"ALL RECORDS" – Delete all records
.
Print stored records. Select:
"UNPRINTED RECORDS" – Print all records not
previously printed.
"ALL RECORDS" – Delete all records.
NOTE:
It is advised not to transfer several records to
the PC at the same time (Diagnostic suite) as
the system is not prepared for this.
If you select "Send records to PC" and transfer "all
records"/"Unsent records", you get the message in
the Diagnostic Suite view: "Overwrite data with new
transferred data"?
Hence, all the records will be sent to the dedicated
folder on the PC and the Diagnostic Suite will ask if
you want to overwrite the current data on the
screen. So it is recommended to send the
individual records by selecting "List records" (in
"Data Management") and select the preferred
record. (NB: Remember to start Diagnostic
Suite/Imp Module before transferring the record).
Set the internal clock date and time.
Select when reflexes will be measured:
"ALWAYS MEASURE" – Reflexes are always
measured.
"NEVER MEASURE" – Reflexes are never
measured.
"ONLY IF PEAK FOUND" – Reflexes will be
measured only if MT10 detects a peak on the
tympanogram.
"PROMPT TO MEASURE" – The user is asked
whether to perform a reflex at the start of at each
test.
Page 8