Use And Operation; Instructions And Warnings For Use; Description Of Controls - Angelo Po BX61E Manual De Uso

INSTRUCTIONS AND WARNINGS FOR USE

Important
Besides being authorised and appropriately documented,and if necessary,instructed and
trained, users,on fi rst usage, have to simulate several operations to identify the controls
and main functions.
Use only as intended by the manufacturer and do not tamper with any devices to obtain
operations other than those intended.
Before use, check that the safety devices are properly installed and in good working order.
As well as undertaking to comply with these requirements, users must apply all safety
regulations and read the description of the controls and the start-up instructions carefully.
– The manufacturer recommends using the oven above 250°C only when strictly
necessary and for short periods of time, not to reduce the life of your equipment.

DESCRIPTION OF CONTROLS

1) On-off button: for switching the appliance' on and
off .
2) START-STOP button: Starts or ends the selected
program cycle, shown on the display (cooking
cycle, washing cycle, etc.).
Green light on ((steady light): cooking program in
pause status or ready to start.
Green light on (fl ashing): cooking program in
progress.
Green light off : appliance on.
3) Convection cooking key: for selecting convec-
tion (fan-assisted hot air) cooking mode.
Green light on: convection cooking mode selected.
4) Mixed cooking button: for selecting mixed coo-
king mode (convection + steam).
Green light on: mixed cooking mode selected.
5) Steam cooking mode button: for selecting ste-
am cooking mode.
Green light on: convection cooking mode selected.
6) Temperature setting button
– STo set the cooking temperature: press once (the
green light fl ashes) to set the temperature using the
knob (10).
– To modify the temperature during cooking: press
once to display the value of the temperature set on
the display (11).Press the button and turn the knob
(10) to modify the value set.
– Changes the temperature unit of measurement
from degrees Centigrade (°C) to degrees Fahren-
heit (°F).
With the appliance in the STOP phase (green light
(2) on) press the button (14) and hold it down for
longer than 3 seconds (the whole panel powers
down).
Press and hold the button (6) and turn the knob
(10) to select temperature display in ° C or ° F. Press
the knob (10) to confi rm the changes made.
3326460_ut_GB_rev.2

USE AND OPERATION

11
14
15
10
- 7 -
3 4 5
6
REAL
7
8
INJ
18
2
12
9
13
17
GB
16
ENGLISH