Skil MS6305-00 Manual Del Propietário página 14

1 . Carrying Handle
This handle is built into the head assembly
for use during transport.
2 . Spindle Lock
Allows the user to keep the blade from
rotating while tightening or loosening the
blade bolt during blade replacement or
removal.
3 . Lock-Off Tab
The ambidextrous tab must be rotated to the
left to activate the power switch.
4 . Power Switch
The power switch energizes the unit when it
is depressed.
5 . Main Handle
This handle contains the power switch.
The blade is lowered into the workpiece by
lowering the handle. The blade is pushed
through the workpiece by pushing on the
handle.
6 . Lower Blade Guard
Helps to protect your hands from the spinning
blade. It retracts as the blade is lowered.
7 . Blade
Use only 10" blades with 5/8" arbor holes.
8 . Fixed Fence
Supports the workpiece.
9 . Insert Plate
Minimizes workpiece tear-out.
10 . Tool Mounting Hole
Four areas to clamp, bolt, or nail the saw to a
flat work surface.
11 . Work clamp
Provides fast clamping of workpiece.
12 . Miter-lock Knob
Locks the miter-saw table at any desired
miter angle.
13 . LED Shadow Light
The LED light casts a shadow of the blade to
help identify where the blade will contact the
workpiece.
14 . Miter Detents Plate with Miter Scale
This scale allows you to read and set the
miter angles easily. There are nine (9) miter
detents on the plate for fast and accurate
miter cuts at common miter angles.
14
15 . Miter-Detent Release Lever
Used with the Miter-Detent Override to
release or engage the table from the miter-
detent plate.
16 . Table
Sits in the base, provides workpiece support,
rotates for desired miter cuts, and rotates the
head assembly.
17 . Base
Provides working surface to support
workpiece.
18 . Table-Extension Lock Knob
There is one table extension lock knob for
each of the table extensions at the back of
the base. Rotate the table extension lock
knob to unlock/lock the table extension.
19 . Table Extensions
Provide extra support and clamping area on
each end of the base. Each table extension
can be locked in any position, from fully
closed to fully open.
20 . Sliding Fences
Provide maximum height support for the
workpiece and slide away from blade for
easy bevel and compound cuts. The fences
also have holes, which can be used to
secure an auxiliary fence.
21 . Head-Assembly Lock Pin
Used to lock the head assembly in the lower
position for easy transportation.
22 . Shadow Light On/Off Switch
Turns the LED Shadow Light system on and
off.
23. Chip Deflector
Protects against large chips entering the
upper guard.
24 . Lower Guard Linkage
Allows for smooth movement of the lower
guard.
25 . Upper Blade Guard
Covers upper portion of the blade.
26 . Double-Ended Allen Wrench
Used for tightening/loosening the blade
bolt, installing/removing the carrying handle,
tightening/loosening the table extensions,
and tightening/loosening screws for the
insert plate and the bevel/miter scale pointer.
The wrench is stored at the right side of the
bevel-lock knob.