Cutting Grooves; Cutting Base Molding - Skil MS6305-00 Manual Del Propietário

NOTICE: Check for interference between the auxiliary fence and the lower blade guard.
Correct any interference before proceeding.
4. Repeat these steps with second board by aligning with right side of miter table and making
a full right miter cut through the auxiliary fence.

Cutting grooves

1. See Depth-of-cut adjustment to set the desired depth of cut.
2. When cutting grooves, a wooden spacer must be placed between the workpiece and the
fence for a consistent length of cut in the workpiece. Use the work clamp to clamp the
spacer and another suitable clamp to clamp the workpiece.
3. Make the slide cut at the desired depth (see

Cutting base molding

Base molding can be cut vertically against fence or flat on the table.
•
Follow the table for helpful hints on cutting base molding.
•
SETTINGS
/
INSTRUCTIONS
Sliding Fence
Bevel Angle
Molding position
Inside corner
of wall
Outside
corner of
wall
WARNING
Interference can prevent
If the head assembly interferes with the workpiece while cutting it on the right side, it is
•
recommended to flip the workpiece and cut it to the left.
40
BASE MOLDING CUTTING INSTRUCTIONS
molding is against the fence
Miter Angle Left at 45°
Molding
position against table
Finished side Keep left side
Miter Angle Right at 45°
Molding
position against table
Finished side Keep left side
Check for interference between the workpiece and the head-assembly
components by performing a dry-run simulation of the cut .
proper saw operation and cause injury and/or tool damage.
To slide
Vertical Position Back of
Fully closed position
0°
Left Side Right Side*
Right at 45°
Bottom Bottom
against table
Keep right
of cut side of cut
Left at 45°
Bottom Bottom
against table
Keep right
of cut side of cut
cut).
Horizontal Position Back of
molding is flat on the table
Move to proper position
Left Side
0°
Top against
fence
Keep left
side of cut
0°
Bottom
against
fence
Keep right
side of cut
45° left
Right Side*
0°
Bottom
against
fence
Keep left
side of cut
0°
Top against
fence
Keep right
side of cut