Skil MS6305-00 Manual Del Propietário página 24

Place the saw on a firm, level surface where there is plenty of room for handling and
•
properly supporting the workpiece .
ONLY lift this saw by carry handles defined in this manual.
•
Preparing to lift the saw
1. Set the bevel angle at 0° and lock it in place, using the bevel-lock knob.
2. Lock both side-table extensions in the inward positions.
3. Rotate the table to either 45° right or 45° left and lock it in place with the miter-lock knob.
4. Loosen the slide-rail lock knob to slide the head assembly through the sliding mechanism
until the position shown in the Fig 14 is attained. Then lock the sliding rail system.
5. Lock the head assembly in the DOWN position with the head-assembly lock pin. (Fig.15)
Fig. 14
Approximately 2-inch
Lift the saw by the carrying handle
Grip the saw by the carrying handle.
Continue to lift and transport comfortably.
(Fig.16)
Lift the saw by the side carry handles
Use upright, good posture and grip the two
handle areas beneath the base. (Fig.17)
24
Fig. 15
Fig. 16
Fig. 17