Makita LS1219 Manual De Instrucciones página 29

2. After adjusting the lower limit position of the saw
blade, cut parallel grooves across the width of the work-
piece using a slide (push) cut.
1
► 1. Cut grooves with blade
3. Remove the workpiece material between the
grooves with a chisel.
Special Max Width Cutting
Capacities Technique
The maximum cutting capacity of width can be achieved
by following the steps below:
For the maximum cutting width of this tool, refer to the cutting
capacities for special cuttings in the SPECIFICATIONS section.
1.
Set the tool at 0° or 45° miter angle and make sure
that the turn base is locked. (Refer to the section for
miter angle adjustment.)
2. Remove both right and left upper fences temporar-
ily and set aside them.
3. Cut a platform to the dimensions indicated in the
figure using a 38 mm (1-1/2") thick, flat stock material
such as wood, plywood or particle board.
3
4
► 1. 0° Miter angle: Over 450 mm (17-3/4") 2. 45°
Miter angle: Over 325 mm (12-3/4") 3. 38 mm
(1-1/2") 4. Over 760 mm (30")
WARNING:
Be sure to use flat stock as a
platform. Stock that is not flat may move during the
cutting operation which may result in kickback and
serious personal injury.
NOTE: The maximum cutting capacity in height will
be reduced by the same amount as the platform
thickness.
4.
equally over each side of the tool base.
Secure the platform to the tool using four 6 mm (1/4")
wood screws through four holes in the lower fences.
► 1. Screws (two each side) 2. Lower fence 3. Base 4. Platform
flat against the tool base and secured firmly to the lower
fences using the four screw holes provided. Failure to
properly secure the platform may result in movement and
possible kickback resulting in serious personal injury.
mounted to a stable and flat surface. Failure to prop-
erly mount and secure the tool could cause the tool to
be unstable resulting in a loss of control and/or the tool
falling which may result in serious personal injury.
5.
fences installed. The upper fences provide the ade-
quate support required to cut the workpiece.
1
If the workpiece is not supported properly, it may move resulting
2
in possible loss of control, kickback and serious personal injury.
6.
secured to the tool.
7.
fences with a vise before cutting.
► 1. Upper fence 2. Vertical vise 3. Workpiece 4. Platform
8.
the operation explained in the section for slide (push) cutting.
29 ENGLISH
Place the platform on the tool so that it extends
1
2
WARNING:
Make sure that the platform is laying
WARNING:
Ensure that the tool is firmly
Install both the upper fences on the tool.
WARNING:
Do not use the tool without upper
Place the workpiece to be cut on the platform
Secure the workpiece firmly against the upper
1
Make a cut through the workpiece slowly according to
4
3
2
3 4