Electrical Connection; Pneumatic Connection - Aventics VS CL03 Instrucciones De Servicio

68 AVENTICS | CL03/CL03-XL | R402000141–BDL–001–AE
Device Description
This must be taken into account with the control. It is possible to
increase the entire number of valve positions to 18, but the
maximum number of controllable solenoids remains 32.
The maximum number of subbases with dual signal is 2 per
valve system.
Also see "Technical Data" on page 99, and the online catalog, for
more information on valve alternatives.
5.2

Electrical connection

The valve system can be controlled via either:
W
Multipole plug
W
Bus module
Available bus protocols are:
W
PROFIBUS DP
W
INTERBUS
W
CANopen
W
DeviceNet
W
DDL (Drive and Diagnostic Link)
W
AS-interface
See "Electrical connection" on page 79 for electrical connection
when a multipole plug is fitted.
For electrical connection when a bus module is fitted, see
separate manual for each type of bus module.
5.3

Pneumatic connection

The valve system is connected to the pneumatic system either
via ports in the connection piece or in the end plate (main
supply, exhaust and pilot supply and exhaust). There are two
options for the main air supply:
W
Via port 1. Ports 3 and 5 will then work as exhaust.
W
Via ports 3 and 5. Port 1 will then work as exhaust.