Starting And Stopping The Machine - Nilfisk RS 501 Instrucciones De Uso

Turn the ignition key clockwise and hold it in the first position.
7.
The following warning lights and indicators turn on:
• Diesel engine glow plug pre-heating warning light (10, Fig. D)
• Charged battery indicator light (8, Fig. D)
• Engine oil pressure warning light (15, Fig. D)
Parking brake warning light (9, Fig. D)
•
The buzzer will also turn on.
When the glow plug pre-heating warning light (10, Fig. D) turns off, turn the ignition key clockwise, to the end of stroke, and
8.
then release it when the diesel engine starts.
CAUTION!
When starting the engine, do not keep the ignition key in cranking position too long (maximum 20 seconds) to
avoid damaging the starter. If the engine does not start, wait a minute before trying again.
Before trying to start the engine again, turn the ignition key counterclockwise, to the initial position.
If the engine does not start after two attempts, do not persist, ask for help from the person responsible for the
machine.
CAUTION!
When starting the engine with the ignition switch (17, Fig. D) do not press the drive pedal (4, Fig. E), because the
machine is equipped with a safety system that does not allow for engine start-up in this condition.
Make sure that all the warning lights are off when the engine is running.
9.
10. With the throttle lever (16, Fig. E) in an intermediate position, let the engine run for a few minutes to allow it to warm up,
especially when the air temperature is low.
Diesel engine stop
11. Turn the engine throttle lever (16, Fig. E) to idle by pressing the lever on the handle at the same time, and hold it in this
position for a few minutes to let the system stabilize.
Turn the ignition key (17, Fig. D) counterclockwise, to the end of stroke, then remove it.
12.
Engage the parking brake with the lever (7, Fig. E).
13.

STARTING AND STOPPING THE MACHINE

The machine can be started and set to:
– Transport mode
Working mode
–
The relevant procedures are shown below.
WARNING!
When steering, avoid abrupt direction changes, pay careful attention and drive the machine at slow speed,
especially when the hopper is full or when operating on inclines.
CAUTION!
Before operating the machine, check that the tire pressure is correct (54 psi (3.75 Bar)) and, if necessary, adjust
it.
Setting the machine to transport mode
To transport the machine (without sweeping), it is necessary to set the transfer mode according to the following procedure:
1. Start the engine as shown in the previous paragraph.
Check that the hopper (12, Fig. G) is lowered and that the warning light (26, Fig. D) is off.
2.
Check that the suction fan is off; see the lever (14, Fig. E).
3.
Lift the safety flange (24, Fig. E), then lift the suction inlet and side brooms with the lever (12).
4.
5. Gradually push the engine throttle lever (16, Fig. E) forward by pressing the lever on the handle at the same time. Adjust the
speed on the display (11, Fig. D) to 2,600 rpm.
Start to transport the machine, by keeping the hands on the steering wheel (2, Fig. E) and gradually pressing the pedal (4), on
6.
the front side to move forward and on the rear side to move backward.
The drive speed can be adjusted from zero to maximum speed by increasing the pressure on the pedal.
WARNING!
The machine is equipped with rear wheel steering. Use rearview mirrors to see rear end of machine when
maneuvering.
WARNING!
In case of obstacles (for example a curb climbing), remind to lift the suction inlet to prevent damage to machine.
INSTRUCTIONS FOR USE
RS 501 33015498(3)2008-02
ENGLISH
15