Bronpi HYDRO Serie Instrucciones De Instalación, Uso Y Mantenimiento página 22

WARNING!
The lack of the baffle plate causes an excessive draw. This
causes a fast combustion, excessive wood consumption
and the overheating of the equipment.
Due to safety reasons during the transport, the baffle plate is not
assembled. You will find it inside the combustion chamber.
On all Hydrobronpi models, the deflector manufactured in vermiculite
(heat refractory material) is supported on four supports that you will find
on the sides (2 on each side) of your device, with different height so that
the deflector remains as shown (see drawings D2.10 and D2.11).
In the Hydronova Plus model, the deflector also of vermiculite, rests on
the left side support located inside the combustion chamber and we must
also fit it with the groove through which the double combustion air exits
(see drawings D2.12 and D2.13).
D2.12
D2.14
• STANDARD FRAME
The four faces standard frame included in models of the Hydrobronpi-E and Hydrobronpi-E-
Vision series is removable. To remove it is necessary to unscrew the 4 screws of the frame (2
on each side) (see drawing D2.16).
D2.16
• ASH PAN
In all the models it is located in the lower part of the thermo-stove. You must open the door to remove
it, extract it outwards to empty the ashes (see drawing D2.17).
ATTENTION!! Make sure that the ashes are not hot when you use the rake and glove to
avoid burns.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
Door closing regulation
It is advisable to check the state of the door joints because if they are not well integrated (that is, they
no longer fit with the front of the device and/or door), they do not ensure the correct functioning of the
thermo-stove! You can regulate the adjustment of the door depending on the situation of the joints through
the screws placed in the front, by tightening and loosening the screws it is possible to get the correct
adjustment of the door. (See drawing D2.14)
Barbecue grill
The barbecue grill is an accessory that is incorporated as
standard, except in the Hydronova Plus model, which does
not have the possibility of placing this grill. It is adjustable in
two heights depending on the slot of the side guide we use
(see drawing D2.15).
In order to avoid the damage of the grill, it is recommended
to extract it when it is not being used.
D2.10
D2.13
21
D2.11
D2.15
D2.17
HYDRO RANGE