Mounting The Deflector - Stihl FS 70 Manual De Instrucciones

English
Mounting the barrier bar
1
3
Fit the washer (1) on the M5x23
N
screw (2).
Hold the barrier bar (3) against the
N
loop handle and insert the screw
with washer.
Tighten down the screw (2) firmly.
N
Leave the barrier bar permanently
mounted to the loop handle.
18
Adjusting and securing the loop handle
0.2 in
(5,3 mm)
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommended distance (A): about
2
14 in (35 cm)
Loosen the screw on the handle.
N
Slide the handle to the required
N
position.
Tighten down the screw so that the
N
handle cannot be rotated on the
drive tube.
A

Mounting the Deflector

Use the right deflector
WARNING
Deflector (1) is approved for mowing
heads only and must therefore be
mounted before fitting a mowing head
2
WARNING
Deflector (2) is approved for grass
cutting blades only and must therefore
be mounted before fitting a grass cutting
blade.
Mounting the Deflector
Deflectors (1) and (2) are both mounted
to the gearbox in the same way.
1
FS 70 RC