Adjusting The Throttle Cable; Mounting The Deflector - Stihl FS 460 C-M Manual De Instrucciones

Adjusting the Throttle Cable

It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
Set the throttle trigger to the full
N
throttle position.
Carefully rotate the screw in the
N
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.
FS 460 C-M, FS 460 C-M L, FS 490 C-M, FS 490 C-M L

Mounting the Deflector

Use the Right Deflector
1
WARNING
Deflector (1) is approved for mowing
heads only and must therefore be
mounted before fitting a mowing head.
2
WARNING
Deflector (2) is approved for grass
cutting blades and brush knives only and
must therefore be mounted before fitting
a grass cutting blade or brush knife.
3
4
WARNING
The limit stop (3) is approved as a
deflector for circular saw blades only
and must therefore be mounted before
fitting a circular saw blade. It is also
necessary to change the guard ring (5),
see "Mounting the Cutting Attachment" /
"Mounting Circular Saw Blades".
Mounting the Deflector
Deflectors (1 to 3) are mounted to the
gearbox in the same way.
6
5
Remove dirt from joints on gearbox
N
and defelector – make sure that no
dirt gets into the screw holes in the
gearbox.
Place the deflector on the gearbox
N
(5).
Insert the screws (6) and tighten
N
them down firmly.
English
23