Tools Required - Waeco PerfectView CRT 100 Instrucciones De Montaje Y De Servicio

The following are required for the installation:
– Scale (ruler) (see B 1)
– prick punch (see B 2)
– hammer (see B 3)
– drill (see B 4)
The following are required for the electrical connection and the check:
– diode test lamp (see B 8)
– or voltmeter (see B 9)
– crimp pliers (see B 10)
– insulating tape
Subject to your individual assembly, you will probably need still more screws, nuts, was-
hers, metal screws and cable-clips than those contained in the scope of delivery for the
fastening of the camera and monitor.
No. Quantity
1 1
1.1 1
1.2 1
1.3 1
1.4 2
1.5 1
2 1
2.1 1
2.2 1
2.3 1
2.4 1
2.5 1
2.6 4

Tools required

– drilling machine
– screwdriver
– screwdriver
– heat shrink hose
– hot-air drier
– hatchet iron
– soldering tin
Scope of delivery RV-100
Designation
Monitor kit RV-50 (see C 1)
Monitor
Glaring protection
Monitor holder
Covering caps
Wiring harness
Assembly set: monitor
Camera kit RV-20 (see C 1)
Camera
Camera holder
Camera protection
System cable 20 m
Insulating board
Insulating coverings
Assembly set: camera
44
(see B 5)
(see B 6)
(see B 7)
(see B 11)
(see B 12)
(see B 13)