Installing Lamp Houses; Attaching The Lens - Sony SRX-S110 Manual De Instalación E Usuario

Preparations

Installing Lamp Houses

The lamps for the light source of the projector are not
installed in the factory.
Depending on the model, install the optional lamp houses
into the projector.
• LKRX-B110 projection lamp house for SRX-S110
• LKRX-B105 projection lamp house for SRX-S105
For the lamp house installation method, refer to the
Operating Instructions supplied with each lamp house.
6
Installing Lamp Houses / Attaching the Lens
Chapter

Attaching the Lens

Attach one of the optional lenses to the projector according
to your purpose.
The procedure below describes how to attach the following
lenses to the projector.
• LKRL-Z115 1.48- to 1.81-times zoom lens
• LKRL-Z140 3.81- to 7.12-times zoom lens
For attachment of the optional lenses not mentioned
above, refer to the mounting instructions supplied with
each lens.
Note
Handle the lens carefully as it is very heavy.
1
Loosen the four screws on the lens cover with a
hexagonal wrench, then remove the lens cover.
2
Holding the lens with both hands, align the holes on
the lens with the positioning pins on the projector, then
insert the lens straight into the lens attachment part.
2
Lens cover