Cleaning And Maintenance - STAMOS S-MMA 200P.IGBT Manual De Instrucciones

4. OPERATION
S-MMA 200P.IGBT (2209) WELDING MACHINE
Machine description:
1
2
3
4
5
6
3
4
No. Function and description
1. Power on indicator.
2. ERROR INDICATOR = The indicator lights in the following two situations:
a) If the machine has malfunctioned and cannot be operated.
b) If the cutting device has exceeded the standard working time, the protection mode is initiated
and the machine will stop functioning. This means that the machine is now being cooled in order
to be able to restore the temperature control again after the device has overheated. Therefore,
the machine is stopped. During this process, the red warning light on the front panel lights up. In
this case it is not necessary to unplug the device. The ventilation system may be left on in order to
enhance the cooling of the machine. When the red light goes dark, this means that the temperature
is set to the normal level and the unit can be put back into operation.
3. Welding current adjustment knob
4. Welding current display
5. „+" Positive output
6. „-" Negative output
7. Mounting handle
8. Handle. Attention! This handle should only be used to carry the machine. It is forbidden to work
with the machine suspended on a shoulder.
5. CABLE CONNECTIONS
INSTRUCTIONS FOR CABLE CONNECTIONS:
1. Connect the mass cable to the socket marked with „+".
2. Then connect the cable with MMA electrode holder to socket marked with the „-" sign.
WARNING! The polarization of the cables can be different! All polarisation information should be
shown on the packaging supplied by the electrode manufacturer.
3. Now you can connect the power cord and turn the power on, once the mass cable is connected to the
workpiece, you can start working.
EN
7
8
1
2
12
Rev. 27.03.2017
6. DISPOSING OF PACKAGING
The various items used for packaging (cardboard, plastic straps, polyurethane foam) should be kept, so that
the device can be sent back to the service centre in the best possible condition in case of any problems!
7. TRANSPORTATION AND STORAGE
Shaking, crashing and turning upside down of the device should be prevented when it is transported. Store it
in a properly ventilated surrounding with dry air and without any corrosive gas.

8. CLEANING AND MAINTENANCE

• Always unplug the device before cleaning and when the device is not in use.
• Use cleaner without corrosive substances to clean surface.
• Dry all parts well before the device is used again.
• Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
9. CHECK REGULARLY THE DEVICE
Check regularly that the device doesn ́ t present any damage. If there is any damage, please stop using the
device. Please contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latter is to be found on the technical plate on the device).
• If relevant, take a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. The more detailed your information, the better the
customer service will be able to answer your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
Rev. 27.03.2017
EN
13