Regular Cleaning - STAMOS S-LS-14 Basic Manual De Instrucciones

SAFETY ISSUES REMARKS
1. Tips can be changed when the soldering iron is completely cold.
2. It is forbidden to use the device near flammable or combustible elements and objects or in similar
conditions. Soldering iron tips have very high temperatures, do not touch these elements! This can
cause serious burns.
3. Too high temperature of the soldering iron may be the cause of reduction of the functionality of the
soldering tips.
4. Soldering iron tip must be cleaned regularly using sponge and plate on a layer of tin to prevent tips
oxidation.
REPLACEMENT OF THE SOLDERING IRON TIP AND SOLDERING IRON HEATING
CORE ELEMENT
5
4
3
2
1
8
7
6
Before heater replacement make sure that the soldering iron is completely cold.
1. SOLDERING IRON TIP REPLACEMENT: remove the nut for mounting the soldering iron tip housing and
take off the housing. Replace the tip with the new one, place the housing and fix all with the plastic nut.
2. HEATER REPLACEMENT: remove the nut for mounting the soldering iron tip housing and take off the
housing along with the tip. Remove the nut for fixing the heater (4) and gently remove the heater (6) along
with the board with wires (7). Replace the whole remembering the wires connection order.

REGULAR CLEANING

Generalities
• Never clean the device with a pressurized water-jet, industrial cleaners, and brushes or any other
type of cleaning utensil that could damage the surface of the appliance.
• Before cleaning you must remove the electricity supply plug isolating the appliance from the main
power circuit.
10
EN
1. nut for mounting the sol-
dering iron tip housing
2. soldering iron tip housing
3. soldering iron tip
4. plastic nut for mounting
the heater and the board
wires
5. spring
6. heater
7. wires board
8. handle
REGULAR CONTROL OF THE DEVICE
Control regularly that the device doesn´t present any damage. If it should be the case, please contact your
customer service to solve the problem.
What to do in case of problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latest is to be found on the technical plate on the device).
• If relevant, a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determine the source of the problem if you
• give a detailed and precise description of the matter. Avoid formulations like "the device doesn´t
heat", which may mean that it doesn´t heat enough or even not at all. Though, those two possibilities
have a different causation!
The more detailed your information, the quicker the customer service will be able to answer your problem
rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to a
loss of warranty!
EN DE
11