baltur TBL 45P Manual De Instrucciones página 40

MAINTENANCE
Carry out periodic analysis of the exhaust combustion gas, che-
cking the emissions.
Periodically replace the light oil filter when dirty.
Check that all the components of the combustion head are in a
good state, not deformed by the temperature and free from im-
purities or deposits from the installation environment or by poor
combustion and check also the electrodes are working efficiently.
If the combustion head needs to be cleaned, remove the compo-
nents following the procedure indicated below:
1) Disconnect light oil pipes 1 from their connectors (careful of
drips).
E
2) Unscrew le screws 2 and remove the lid 3 (figure 1).
N
3) Unscrew nut 4 on the inside of the scroll burner and remove
G
pawl 5 with screw 6 that regulates the position of the mixer
assembly (figure 2).
L
Important: Before carrying out the above procedure, store in
I memory the exact position of the mobile plate marks 7 relati-
ve to the reference on the scroll burner. Once the maintenan-
S
ce operations have been completed, this will make it possible
to return the mixer assembly to the same position it was in
H
last time it was adjusted.
4) Slightly lift mixer assembly 9 (figure 3) and then competely
remove the assembly in the direction indicated by arrow
9, after having removed the cables 10 from the respective
electrodes.
5) To complete the maintenance operations proceed with the
reassembly of the mixing unit by carrying out the above ope-
rations in reverse order, after checking the ignition electrodes
and the deflector disk are correctly positioned (See diagram
0002935430).
38 / 89
0006081349_200802
figure- 1
figure- 2
figure- 3