Details Of Suntec Pump - baltur TBL 45P Manual De Instrucciones

DETAILS OF SUNTEC PUMP

AS 67A 7466
1 ELECTROVALVE (USUALLY CLOSED)
2 PRESSURE TEST POINT AND PURGE POINT (1/8" G)
3 PRESSURE REGULATION SCREW
3.1 REMOVE THE NUT TO HAVE ACCESS TO
THE PRESSURE ADJUSTMENT SCREW (11 ÷ 14 BAR)
4 RETURN
INSTRUCTIONS FOR THE ADJUSTMENT OF THE OSCILLATING JACK
Adjustment of 1st flame air damper position
1) To increase air supply capacity, turn ring nut C1 anticlockwise;
use counter wrench on body A of the jack to prevent too much
being exerted on eyelet H's pin. This action lowers body A and
favours the opening of air damper F in first stage.
To reduce the flow of air turn ring nut C2 clockwise, also in
this case use the counter wrench on the body of the jack. In
this case body A is raised and favours the closing of the air
damper F.
2) After adjustment of the 1st flame air, lock the two ring nuts C1
and C2.
Adjustment of 2nd flame air damper position
1) Slacken the locking nut E.
2) To increase 2nd flame air flow, slacken screw D; in this way
the travel distance of the hydraulic piston will be lengthened.
To reduce air flow tighten the screw.
2) After 2nd flame air flow adjustment, tighten nut E.
N.B. To avoid damaging eyelet H, carry out all the adjustment ope-
rations with use of wrench and counter wrench.
AN 47 - 57 - 67 - 77 - 97
0002900681
rev.08/08/07
N.B. The pump is preset at a 12 bar pressure.
Legend:
C1, C2 –
39 / 89
0006081349_200802
4.1 WAY-BACKWITH SCREW OF INNER BY-PASS
5 SUCTION
6 DELIVERY
7 VACUUM TEST POINT (1/8" G)
7.1 VACUUM GAUGE COUPLING
A – Hydraulic jack body
B – 1st flame adjustment screw
Ring nut for the adjustment and locking in position of
1st flame air damper
D – Adjustment screw for 2nd flame air
E – Locking nut
F – Adjustment air damper
G – Air intake
H – Support eyelet
0002900331
rev. 05/04/96
E
N
G
L
I
S
H
N°0002935420
REV.: 03/12/07